Need a hot melt box gluer?
Send us your box style and dimensions (L × W × H) – we will check the fit and send you a price quote.
Glues the side seam of corrugated boxes in one pass with a Robatech hot-melt system – approx. 10 boxes per minute, run by one operator. The perfect partner for your box maker in short and medium runs.
GET A PRICE quoteThe AOPACK AG1250 Hot Melt Gluer glues the manufacturer's joint (side seam) of corrugated boxes in a single pass. The operator feeds the folded blank, the machine applies hot melt evenly along the full length of the glue flap and bonds it to the side panel – the box comes out flat, square and ready to use. In Return Mode the glued box comes back to the feed end, so one operator feeds and collects boxes from the same position; in Single Pass Mode the box exits on the other side. Equipped with a Robatech hot-melt system (8 kg/h), the AG1250 handles FEFCO 0201, 0203 and 0206 boxes – even with flaps of different lengths. Designed for short and medium runs, it is the perfect partner for AOPACK box makers: blanks from the box maker are turned straight into finished boxes. For larger boxes, the AG2500 version handles L + W up to 2,500 mm.




Send us your box style and dimensions (L × W × H) – we will check the fit and send you a price quote.

8 kg/h melt rate, heats up to 160 °C in approx. 30 min. Runs EVA, PO, low-temperature, APAO and PSA hot melts in granules or blocks, refilled from the top.

Hot melt is applied evenly along the full length of the glue flap (30–50 mm) and bonds it to the side panel in a single pass. The edges line up along the entire seam.

The glued box comes back to the feed end, so one operator feeds and collects boxes from the same position. Approx. 7 boxes per minute.

Straight-through gluing – the box exits on the other side of the machine. Approx. 10 boxes per minute, feeding speed up to 40 m/min.

HMI panel with start, stop and emergency-stop buttons for mode selection and gluing parameters. Compact frame, only 780 mm deep.

Regular slotted container – the most common corrugated box, glued on the manufacturer's joint in a single pass.

Full overlap container – the outer flaps overlap fully; the AG1250 glues its side seam just as easily.

Even boxes with unequal flaps (e.g. FEFCO 0206) are glued in one pass. Box height (joint length) from 100 mm, blank width from 350 mm, board 2–8 mm.
Box stylesFEFCO 0201, 0203, 0206 and similar | Max. box sizeL + W ≤ 1,250 mm, L ≤ 625 mm |
Min. blank width350 mm | Joint length (box height)≥ 100 mm |
Glue flap width30–50 mm | Board thickness2–8 mm |
Output – one-way modeapprox. 10 boxes/min | Output – Return modeapprox. 7 boxes/min |
Feeding speedup to 40 m/min | Operators1 |
Hot-melt systemRobatech, 8 kg/h | Heat-up timeapprox. 30 min to 160 °C |
AdhesiveEVA, PO, low-temp., APAO, PSA – granules or blocks | Adhesive viscosity400–20,000 mPa·s |
Power supply380 V ±10 %, 3-phase | Powerheating 7.5 kW, total 9 kW |
Compressed air5–6 bar | Machine size1,900 × 780 × 1,350 mm (L × W × H) |